Hi everyone. I am building the workbee cnc with black box controller. all my wiring is corect but i have no movement on my Y motor drive but i do have it on my Y2 drive. swapped both cables and confirmed the box is not putting out on the Y port plug. Is there an internal or firmware setting I have wrong? I have set up the firmware as per i9nstructions.So im thinking i may have a faulty black box! None of my motors are coupled to the lead screws yet. Hoping someone can help. The Y port is holding the stepper stiff when plugged in just no rotational movement from the Y port. Regards Dave
Thankyou. I will try and go through this link. My phone is not liking the link so will attempt home pc later. Dave
