Welcome to Our Community

Some features disabled for guests. Register Today.

Newbie Going Nuts

Discussion in 'Controller Boards' started by RJT, Apr 28, 2015.

  1. RJT

    RJT New
    Builder

    Joined:
    Dec 16, 2014
    Messages:
    2
    Likes Received:
    0
    I,like many here, have been bit by the CNC bug. After too much research I'm going to build a large OX. The only thing holding me back is the electronics portion of the build. After reading for hrs (maybe too much). I can't decide on the electronics setup.

    I don't know if I'm focusing too much on the problems people are having.

    I plan to start cutting some wood projects, nothing complex, gears etc.

    I'd appreciate any suggestions on what you think a newbie should use. I don't mind starting off one way and upgrading later once I figure out what I'm doing.

    Is there anything that would be easier to setup and get cutting (get my feet wet with) and then move up (upgrade) to some thing else.
    Thanks in advance for any suggestions.
     
  2. Tweakie

    Tweakie OpenBuilds Team
    Moderator

    Joined:
    Jan 18, 2014
    Messages:
    784
    Likes Received:
    326

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice