Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Open rail plate

Discussion in 'General Talk' started by RHightower, Jan 15, 2014.

  1. RHightower

    RHightower New
    Builder

    Joined:
    Jan 12, 2014
    Messages:
    11
    Likes Received:
    2
    Will this work on the v-slot extrusions directly or is the spacing off to fit the open rail system?
     
    #1 RHightower, Jan 15, 2014
  2. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,758
    Likes Received:
    2,440
    The hole spacing's for the OpenRail plates are not the same for the V-Slot gantry plate
    You can bolt OpenRails directly on the VSlot or any 20 series extrusions and then use the OpenRail plates.
    But you cannot use the OpenRail plates directly on the V-Slot tracks that is what the V-Slot gantry plate is for.
     
    #2 Mark Carew, Jan 15, 2014
  3. RHightower

    RHightower New
    Builder

    Joined:
    Jan 12, 2014
    Messages:
    11
    Likes Received:
    2
    Thanks!

    I wasn't sure. From the picture the open rail plate looked like an easier to deal with size than the v-slot so I figured it wouldn't hurt to ask. :)
     
    #3 RHightower, Jan 15, 2014
    Mark Carew likes this.
  4. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,758
    Likes Received:
    2,440
    NP They are actually confused a lot and we have been working on ideas to make them a little more individualized at a glance.
     
    #4 Mark Carew, Jan 15, 2014

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice