Welcome to Our Community

Some features disabled for guests. Register Today.

ox backlash values

Discussion in 'CNC Mills/Routers' started by Jeremy R, Jun 15, 2016.

  1. Jeremy R

    Jeremy R New
    Builder

    Joined:
    Jun 15, 2016
    Messages:
    4
    Likes Received:
    1
    I am using dual GT2 3MM belts for X and Y axes. Using a dial gauge, I have measured backlash to be approximately 0.10-0.12mm for each axis. Are these pretty typical values for this setup?
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice