I would like to create a variation on the workbee. I plan to use two c-beam actuators [pre-assembled] for the side rails, and a third for the gantry. How do I attach the gantry actuator to the plates on the side actuators?
The C-Beam plates have through holes: You can run M5 screws through the holes, into M5 tapped ends of the Gantry beam? Reinforce with some corner connectors: OpenBuilds Part Store
Peter, I considered that but as I do not have hands on I was unsure if there was sufficient overlap on the plate to do so.
https://3dwarehouse.sketchup.com/by/openbuilds - its always a good idea to test the mockups in CAD (Sketchup Make is still free and easy)
I tried to view the 3d model but it wont run on my pc. Downloaded the file and don't have what to view it with. I will try again later from home. Thanks for the resource, did not know it was there.
