Hi all. Just wondering if someone could help me with this touch probe I purchased from Ooznest in the U.K. I’ve seen quite a few of these plates with through holes and apparently it’s used to set up the XY datum position but I’ve no idea how to set it up. Can anyone point me in the right direction please?
Seeing as its Ooznest, are you using Duet or a Grbl based controller (affects the reply sorry need to know)
As @Peter Van Der Walt said, but also if Duet what version of the firmware - big changes recently. Alex.
This should help @Rob Atha ; Setup a XYZ Touch Probe with a CNC xPro Controller At the bottom of the page there are two docs - 1 explains the macro, the other how to calculate the numbers needed. Alex.
