Welcome to Our Community

Some features disabled for guests. Register Today.

Update

Discussion in 'CNC Mills/Routers' started by A.J.W.E. Klappe, May 3, 2022.

  1. A.J.W.E. Klappe

    A.J.W.E. Klappe Well-Known
    Builder

    Joined:
    Aug 13, 2017
    Messages:
    134
    Likes Received:
    88
    hello all

    I saw that my computer was working on the new update of Control but it did not run it completely and therefore did not update automatically. I saw that the update had reached the full 100 percent but after that nothing happened. In previous cases I had to restart control but not this time. So it is still at 0.317. What can I do in this case.
    thank you in advance.

    Bert

    Problem solved
     
    #1 A.J.W.E. Klappe, May 3, 2022
    Last edited: May 3, 2022

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice