Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

USB communication with BlackBox Motion Controller

Discussion in 'Other Software' started by Wolfgang Märzinger, Aug 7, 2020.

  1. Wolfgang Märzinger

    Wolfgang Märzinger New
    Builder

    Joined:
    Aug 6, 2020
    Messages:
    2
    Likes Received:
    0
    I would like to communcate with the BlackBox Motion Controller directly via USB from my own software. Is there any documentation on how to do this (port settings, commands etc.)?
    If no, does anyone have experience with this?
     
    #1 Wolfgang Märzinger, Aug 7, 2020
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    15,224
    Likes Received:
    4,349
    Protocol is entirely documented on the Grbl Wiki: gnea/grbl
    Connect at 115200 Baud
     
    #2 Peter Van Der Walt, Aug 7, 2020
  3. Wolfgang Märzinger

    Wolfgang Märzinger New
    Builder

    Joined:
    Aug 6, 2020
    Messages:
    2
    Likes Received:
    0
    Thank you for this input. Now it is working. The important point in my case was to disable the interface echo messages using the command stty -echo
    Before I did this I received a lot of error messages error:9
     
    #3 Wolfgang Märzinger, Aug 12, 2020

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice