Welcome to Our Community

Some features disabled for guests. Register Today.

V-Slot vs. Open Rail style CNC Mill/Router...?

Discussion in 'CNC Mills/Routers' started by Tony LaBelle, Feb 8, 2016.

  1. Tony LaBelle

    Builder

    Joined:
    Nov 27, 2015
    Messages:
    54
    Likes Received:
    6
    Hi All,
    I'm finally up to the point where I'm about to hop into the parts store and start purchasing parts. I basically made two sets of drawings...trying to decide which road to take as far as using V-slot or Open Rail. So...what style does everyone feel is the most accurate of the two. I'm not leaning either way at this point. Any and all suggestions would be very appreciated. I have a good metal shop setup, so if that has any bearing on which way to go. Look forward to everyone's response...and Thanks abunch for the help!!!

    Tony.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice