Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

xPro V3 on OX cnc - Y Axis question

Discussion in 'Controller Boards' started by OxCarver, Mar 24, 2020.

Tags:
  1. OxCarver

    OxCarver New
    Builder

    Joined:
    Apr 14, 2017
    Messages:
    6
    Likes Received:
    2
    My OX cnc runs on xPro V3 control board. I just noticed when I jog the Y-Axis only the LED indicator of the driver on one side ( on the board ) blinks. Is this normal ? Short of unplugging the steppers one at a time, how can I check if the stepper drivers are actually functioning as expected ( I am very sorry if this is another totally nooob question )
     
    #1 OxCarver, Mar 24, 2020
  2. Giarc

    Giarc OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jan 24, 2015
    Messages:
    3,017
    Likes Received:
    1,682
    I would think that if it is not binding up, it is probably working.
     
    #2 Giarc, Mar 25, 2020
    Peter Van Der Walt likes this.
  3. OxCarver

    OxCarver New
    Builder

    Joined:
    Apr 14, 2017
    Messages:
    6
    Likes Received:
    2
    No binding at all. In fact the step/mm is bang-on accurate even at 500mm distances jogging.
     
    #3 OxCarver, Mar 25, 2020
    Peter Van Der Walt likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice