Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

xPro V5 - noob config setup

Discussion in 'Controller Boards' started by Jacques4000, Apr 20, 2024.

  1. Jacques4000

    Jacques4000 New
    Builder

    Joined:
    Apr 20, 2024
    Messages:
    2
    Likes Received:
    0
    Im setting up the machine settings by following some online videos. was able to invert x and z axis. However Y axis wont invert with the same command. Would this have something to do with the fact that it is a dual axis? Second motor is connected to A axis on controller.

    Machine is a Workbee 1515 leadscrew driven, dual y
     
    #1 Jacques4000, Apr 20, 2024
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    15,191
    Likes Received:
    4,346
    Please contact the vendor you purchase from for assistance
     
    #2 Peter Van Der Walt, Apr 20, 2024
  3. Jacques4000

    Jacques4000 New
    Builder

    Joined:
    Apr 20, 2024
    Messages:
    2
    Likes Received:
    0
    Apologies didn’t realise this forum was only for Openbuilds products
     
    #3 Jacques4000, Apr 20, 2024

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice