Hi Guys, I have my machine up and running now (Just tonight) On my Control software where it displays the location of X,Y,and Z Axis it just says disabled. What the Heck??? anyone seen this problem??? Also I tried homing my machine a 1500 X 1000 WorkBee with Lead Screws ..... My limit switches are working but it is not homing ..... it says I need to configure the size of my machine, I just chose the 1510 Workbee in the drop down list for configuration... Any help Would be Greatly appreciated!!!!
Troubleshooting tab > Application Diagnostics button on the menu at the top. Untick Disable DRO (mustve gotten clicked accidentally at some point)
read this gnea/grbl then set $130 $131 $132 to the correct values In OpenBuildsCONTROL click the 'GRBL settings' tab and change the values, then click 'Save to firmware' button at top left
Which the profile does set too - perhaps you did forget to click Save and then reset when prompted (some settings take effect after restarting Grbl)
Thanks much Peter I just utilized your answer to address similar issue with DRO function to re-enable XYZ coordinate reading on GCODE sender
