Measure your machines actual working distances (travel from one end of each axis to the other) - or if its one of our standard machines, just load the relevant profile from Grbl Settings:
Thank you, Peter. I thought it was only used if enabled soft limits so I stayed away from that. So now I can continue with my initial problem. Love you guys OpenBuilds Rocks
When I try to set my origin off of the back right of the material via the advanced settings it probes in the X+ and Y+ directions (i.e. off the touch plate). How do I get it so it recognizes the plate/probe orientation correctly? FYI, I do have the X axis inverted in the GRBL settings because I put my motor on the left side of the gantry but I would think the settings on the probe would take that into account.
