Hi my y1 is stable but y2 is intermittent in direction but step may be consistent. It is hard to tell. I have checked connections. They seem ok. Could this be a symptom of a broken stepper motor. Also I put in a new Interface, the BB is 2.7. It seems that all the jumpers are in the correct place for new Interface. The old and new Interface exhibit the same problem. Could I have messed up something in the BB? your help is appreciated john raney
I know you said you checked the connections, but that really is a typical symptom of one poor connection out of the four . Check that you haven't clamped onto the insulation instead of the bare wire. Alex.
Yes had the same problem found a solder joint under some heat shrink on the back of a plug faulty Thanks for the help as usual
