Z azis issues

David the swarfer · Oct 28, 2023

Casman said: ↑

I think I'm giving up on this blackbox controller. I think it's an internal problem. I can never turn it on and it works and it always goes back to the initial problem of either jogging too slow or too fast after it appears as if I get it working. Once the machine is idle or a day after, the z stepper never functions correctly. It was the same when it was on the 4x4 cnc newbie, which is working fine with my xcontroller now. I've tried everything that's possible giving the benefit of the doubt that I am doing something wrong but it's definitely the blackbox controller that faulty. I've backed and use grbl settings when I thought it was working then it stops working correctly with the same settings. I've changed out the stepper motor, new wiring, grounded the machine even though it was never an issue.
This is not gcode, Grbl settings, wiring, mechanical issues etc etc etc. This blackbox is faulty.. I'm really fed up.
Click to expand...

then you have recourse to the store support system Support
remember these forums are free support from community members to community members. if you have a problem with the product you need to contact the store!

Forums

Welcome to Our Community

Z azis issues

David the swarfer OpenBuilds Team
Staff Member Moderator Builder Resident Builder

Share This Page

About Us

Support Open Source FairShare Program!

Useful Searches

Welcome to Our Community

Z azis issues

David the swarfer OpenBuilds Team Staff Member Moderator Builder Resident Builder

Share This Page

David the swarfer OpenBuilds Team
Staff Member Moderator Builder Resident Builder