Hi! I have a Two Trees TTC 450 cnc mill that uses a DLC32 2.1 board and comes with a Z touch plate probe. I was wondering if I can upgrade that to the OB XYZ probe. This is the probe information according to the DLC32 manual: Pins: S G 5v Probe interface: When using CNC firmware, this interface can be used as a probe. When using the laser engraving machine firmware, this interface can be used as a flame detection function. The input signal voltage is 5V, the signal interface is S, and a 5V power supply interface is provided to supply power to the modules that need power supply.
Rad, Had the Same question.. Now for a “TTC 450” profile for set up wizard in the open-builds control software…
Our profiles are just templates that populate the grbl settings form below for our machines. Read the fine print for each section. If your machine is in working order, don't mess with the settings. Or at least backup before you do. Its already setup, you don't need a profile to load settings for you. Custom machines has no "profile" in CONTROL - it just has its settings, all saved to the controller (standard grbl wiki Grbl v1.1 Configuration stuff, have a read through it) - we provide a backup button so you can keep it safely backed up. If you need settings for your machine, ask the machine vendor. We provide our machine's in the dropdown, but everyone else can just restore backups or enter settings manually
