Separate names with a comma.
Some features disabled for guests. Register Today.
Gerald I'm sure everything is just fine with the DXF in question and its just the quirky way different programs open the files as you suggested in...
I'm sure when you did. Personally I'm not denying that, but just going on what other people on other forums were saying. Michael.
Thanks Rick, I'll give that one a try. Michael.
There was post in the resources section: OX Plates REV80 in DXF inches format Which I downloaded, but had trouble finding a program to open them....
Thanks a lot Mark Well firstly I have some good news. Adafruit offered to replace the board, but I said no, because I would have to fork out...
Further to my first post here, the board turned up this afternoon (Tuesday) damaged I'm afraid to say. Several pins on the bottom of the board...
Thanks Mark Of coarse it helps. I owned several boats when I was younger and building my first CNC router reminds me of the bottomless pit. There...
Hi all When Mark was building the OX he used a grblShield v.5, but was saying at the time that he may update it as the Nema 23 would need more...
I would hope other people would have seen my post above and saved themselves some grief. My advise would be to get your stuff from Openbuild (I'm...
Thanks Steve It was a bit (excuse the pun) confusing with all the router bits on offer. I've bookmarked the page you suggested for future...
I have a long way to go before my first cut, but have a nagging thought that keeps cropping up every now and then. What type of drill do I need...
Hi Kermarag A word of caution concerning Vslot/Europe. I'm building the OX and bought most of the bits and bobs from OpenBuilds store. But...
