Separate names with a comma.
Some features disabled for guests. Register Today.
Do a forum search. There’s plenty on the subject. Unless the design you have shown is for use with C-Beam extrusion, it’s not a workable concept....
80/20 T-slot is not compatible with OpenBuilds wheels and gantry systems. V-slot was created to remedy the wallowing problem that wheels have in...
My question is why you need a curve. Rolling extrusion into a curve is fairly simple. Doing it without some distortion though is nearly...
Honestly, just an angle bracket support at midspan on the inside face of the long rails will do the trick. As for the controller, you can easily...
They’ve been redoing the menu structure so it’s probably an oversight. Easily found though with the search bar. OpenBuilds ACRO System As for...
I can see it leading to accuracy issues. Would be fairly minor so depending on the required level of accuracy this may not be an issue....
You've solved one of the two largest problems. The other would be belt sag over the 4m distance as the belt hangs below the bottom side of the...
Prayers for the OpenBuilds family. Stay safe y'all.
I'm not sure how you're separating the forward force from the back force but let's just work with the back force as a static load. That 200 pounds...
No, the kits from this site won't go anywhere near that level of force. You'll need something far more industrial. Pneumatic actuators might also...
Simple case of replacing pieces of extrusion. And one lead screw. X is definitely the way to go though. You may want to add another rib under the...
Have you had a look at the build manual posted on the files and drawings tab?...
Have you tried Inventables?
It would be beneficial if you could provide photos of where you’re starting from.
