Separate names with a comma.
Some features disabled for guests. Register Today.
docs:interface:wifi-upload [OpenBuilds Documentation] is the only option at this time. Browsers prevent access to IP/LAN based devices directly
Yes, but those are diodes... Not the same thing now is it? Diodes are around 5-6w. Co2 could be anything from 40w to 150w I ask questions,...
Personally, I wouldn't use leadscrews for a CO2 laser, you need speed. Typically belts... See Lasers category LASER - PLASMA BUILDS | OpenBuilds...
NEMA 23 Stepper Motor is the regular (fine for a LEAD, included by default), with NEMA 23 Stepper Motor - High Torque Series as the upgrade too it...
Order from OpensPartstore. If you want something proven. Its better (low inductance)
Electronics - Stepper Motors - OpenBuilds Part Store 3v coils, +-1mh inductance. Best of the best
Steppers are constant current devices. Their coils are constant resistance, thus the voltage varies to make ohms law true. That's the stepper...
For a laser you want to focus on low inductance and low coil voltage (high inductance is self-braking, and higher coil voltage limits...
They have higher inductance so will lose some top end speed. They will work but our High Torque motors would be better Why do you need stronger...
5mm per rotation. BlackBox X32 is 1/8th microstep, and our motors are 200 steps per rotation. 200 x 8 microsteps = 1600 steps per rotation. One...
That tool is just a calculator. You can use it to calculate ball park steps-per-mm and then fine tune using calibration. It offers calculators...
Depending on what you see (port reset, serial corruption) docs:blackbox-x32:faq-emi [OpenBuilds Documentation] would be worth a read, and ties...
The Serial Terminal tab's log would have had clues
Definately implemented in the V1.2s, they'll phase in in-time. Its really an over the top improvement as it only becomes a problem when a couple...
It should be there: (Next to the hole on the main board) - if not its an old rev. Big warehouse, old and new stock tends to float around. [ATTACH]
Yes, See Reply #7 above But its a paired combo. What you set in the controller settings, you also have to make sure your CAM knows about it,...
You have only got S1 = 1/1000 = 0.01%? Should be S1000 - Check toolpath settings. Both M3 and M4 is bad too: one or the other, not Both... The...
Ok cool,so you do have $30=1000 ; Maximum spindle speed, RPM $31=0 ; Minimum spindle speed, RPM $32=1 ; Laser-mode enable, boolean Laser...
Welcome anytime, and no worries, grblHALs new more advanced settings can be tricky (but super powerful)
Per your backup you have $44=3 ; Homing cycle 1 $45=3 ; Homing cycle 2 The bitmask is 1=X, 2=Y, 4=Z 1+2 = 3 so both cycles are XY at the...
