Separate names with a comma.
Some features disabled for guests. Register Today.
No particular requirement. Does not make any difference
From video - firstly I am surprised you still have a controller (faster spins = more voltage backfed) but looks like the shaft coupler spins on...
Please never spin a motor by hand. A motor spun backwards becomes a generator - backfeeds the stepper drivers - causing damage to your controller!
As I haven't been able to download your video yet (Internet/ISP issue on my end) consider the following generic advice: - As its been in use for a...
Sounds good! PS Control can be used with Arduinos running Grbl 1.1f or later as well, just FYI
Use the grblHAL Web Builder: http://svn.io-engineering.com:8080/?driver=ESP32&board=BlackBox%20X32 Set the Z-axis to Ganged (This uses Y2 as Z2)...
With reversed direction, your error mirrored, so still the same root cause It is mechanical. its not software/firmware, these things are decades...
Let us know what they say, its an interesting one
That confirms an issue with Z wiring or sensor itself That double confirms the BlackBox and settings is fine, so you'd have to a) Recheck the...
That, is the old Grbl for 8-bit ATmega based controllers If you have an x32 you aren't running Grbl. You are running grblHAL! So, simply head...
At the BlackBox flip the Z and Y connectors. See if the problem follows the swop a) "Y" which is the switch on Z stops working or b) "Z" stops...
Possibly Z axis sensor is different type? (PNP vs NPN) NPN sensors are the only supported type, and should work with the default machine profiles...
If all the sensors are the same it should be either $5=7 or $5=0 (depending on the specific type of sensor)
Rotational torque would be an issue there. I'd use a large bearing setup to carry the tool weight for the rotational axis, with a reduction...
As per the reply to the previous poster, same advice applies: Please contact the store
200 steps per rotation - with a microstep driver you can interpolate somewhat. In your rotary application, you would have to use math to take...
You can screw into the pre-threaded front holes of a Jog Knob but its its for attaching to our 8mm leadscrews, sadly not a direct fit onto the...
You can come up with several optional solutions: - Use multiple NO probes wired in parallel connected all at once - Use combination of probes,...
Please contact the store via Support > New Ticket for specific cut to order requests
CONTROL is aimed at the Ease-of-use market, but you can already use other Hosts like ioSender, Candle etc for that
