Separate names with a comma.
Some features disabled for guests. Register Today.
The Advanced positions all probe from front-left too, the offsets are set mathematically. Note the wording of the onscreen text (and position of...
3 axes, with Y set to Ganged on first tab On the plugins tab, enable SD Networking tab: set WebUI to V3 and enable the Telnet server for CONTROL...
Basically yes. Just convert the Y motors to parallel wiring on Y1, frees up Y2 that becomes A when you flash the 4-axes firmware from CONTROL
Reload the stock profile: CONTROL > Grbl Settings tab > Select machine from the list > Save and reset when prompted
Did you remember to power on the 24v PSU? It also powers the 10v circuit, so the lack of voltage suggests the 24v supply is off/disconnected
Should be built in - I don't recall having to hunt one down - been a while since I used it though.
Wrap is very different from "4-axes" work... Wrap around A is possible in Vectric... but its not "4th".... Its 2+Rotary (X, Z and A for example)
So this still leads me to believe you might be in the dark (As Vectric is a 3-axes CAM in foundation) 4-axes is not just gcode but fundementally...
DeskProto is good too (Haven't used its 4-axes mode but have used it for lathe on the old BlackBox before). At the end of the day, you want a...
That's incorrect: The BlackBox X32 was launched a couple months ago... Its predecessor, the BlackBox 4X was only a 3-Axes controller running grbl...
Checkout out the Product Tour will help you to familiarise yourself with the hardware: docs:blackbox-x32:layout [OpenBuilds Documentation]
Check docs:blackbox-x32:currentadjustment [OpenBuilds Documentation] - if the fault indicator is lit when powering up, refer the 2nd half of the...
Can you move the z axis up/down by hand (with some force) ie checking for play?
The minimum output current is around 1.2A (perfect for our NEMA17s). If yours are overheating they may be too small for use with BlackBox
Doesn't accommodate bowing, twisting, etc. How you clamp comes into play too (for example edge clamps cause sheets to bow upward) . After planing,...
Yes please - we'll be sure to tell them its Beta
Our Fusion post: docs:software:fusion360 [OpenBuilds Documentation] May need to tag in @David the swarfer to confirm if the fusion post does 4th...
Correct, just use a 4-axes CAM
First flash the 4th axis firmware then it will show up. Connected to 3 axes machine, it only shows relevant 3 axes UI
Correct, that is how its done and works just fine
