Separate names with a comma.
Some features disabled for guests. Register Today.
Checkout docs.openbuilds.com/blackbox-x32 to learn more about it. No external drivers (plug and play system). Post complete motor specs to...
[MEDIA]
Grip the endmill and give it a wiggle. Human's touch sense can detect much smaller movement than our other senses, so using the sense of feel,...
Definately. Autosquaring is hard to do right - and ultimately - fixing a machine that was built weakly, or out of square in the first place....
You can't square two axes with the BlackBox. Only one. X or Y. Building the machine squarely might be much simpler
Your choice: Runaways are rare, just check when you CAM that you are within bounds. - Can always enable Soft Limits if you are worried (Make sure...
You can compile grblHAL using the grblHAL Web Builder: 1) Wire up the 2nd square-axis switch in parallel to Z (As XY homes seperately from Z, the...
Yes, that's all it takes.
Did you remember to flash the Door firmware from Wizards and Tools > Firmware flashing tool?
You have access to Vectric support as part of your licence, if you don't mind checking in with them, they may have other Posts available. You want...
You can test the above one
1) As you had a working setup, did you follow the Backup/Restore process to transfer the working settings? 2) Relay: Please contact the store...
Checkout the GrblHAL Web Builder to customize firmware to specific needs: http://svn.io-engineering.com:8080/?driver=ESP32&board=BlackBox%20X32...
Only the X32 is available, the 4X is not supplied anymore. Identifical stepper drivers on both though, so no difference
CONTROL > Grbl Settings tab > Select machine from the list > Save and reset when prompted
Yes they should run, but will be a little underpowered on amperage. Will have good acceleration and okay'ish top speed (coil voltage and...
Keep both wired, but power on the relevant device only. Want to use laser? Power off the router, power on the laser.
Try a test without the powerline ethernet adapter. Those tend to be quite flaky around machinery, switch mode PSUs, spindles etc.
OpenBuilds motors or 3rd party?
Use pocket operation
