Separate names with a comma.
Some features disabled for guests. Register Today.
In the toolpath options, open the Advanced dropdown and enable Merge Geometry. If you have an outside and inside line selected, and merge, it will...
If it was calibrated before it might be mechanical (calibration doesn't drift, so unless you changed Grbl Settings afterwards is should be what it...
Run the Calibration tool under Wizards and Tools and check (:
Could be binding mechanically ( check that it can move freely where it gets stuck) Could be wiring docs:blackbox-x32:faq-identify-motor-coils...
Thanks for the report. If you have a Windows PC nearby, for now would be best. Or try the Deb version (AppImages runs in sandbox)
Do you remember to set the Origin in G55? Ie go into G55, then Probe or SetZero to establish where the stock is? Always Home > Set origin > run...
Worth noting all of its very conservative - beginner friendly, reliable. Lost of scope for tuning if you want to get more from it...
Speeds differ because machine is bigger and heavier. Enertia mostly. Direction invert differs because 1010s Z axis is different from 1515....
Post the gcode for review please. Also, how are you setting origin in CONTROL (describe your exact steps from powering up machine)
It might deform the slot a little, but as in this orientation where it goes isn't also used as slot for a wheel, it should be fine.
Looks more mechanical in nature. Check all wheels are properly adjusted, and that the shaft couplers on the leadscrews doesn't have setscrews that...
We've never had issue with plate thickness, but you can check screw length to see if it agrees with the video step. Perhaps used wrong screw...
Your threads are both up (has always been): See Issues assembling Lead 1515 (and Lead 1515 which was closed as its a duplicate of the first) The...
Duplicate of Issues assembling Lead 1515
As mentioned above Remember to Home, or recheck your Homing Dir settings. Have a read through the Grbl Wiki at github.com/gnea/grbl/wiki
Then you should have standard firmware. You'd probably know if you flashed something non-standard to it using some 3rd party instructions or a...
Thats the machine extents. Remember to Home to make reality line up with the view (if that doesn't happen you aren't running standard Grbl, or...
After probing, your Gcode can set the pierce and cut heights correctly. It only rides high spots (unavoidable, but rarer) most of the cut happens...
It is not a supported configuration at this time. We recommend using a drag-head: See video below, around 9min onward (Whole video is worth...
I can see the support team is already responding to your seperate email query regarding the same topic. To avoid duplication lets continue with...
