Separate names with a comma.
Some features disabled for guests. Register Today.
Did you follow all the setup steps in the BlackBox X32 documentation? Possibly skipped step 7.1? (Reading through Section 7.2 relates, so also...
Also have a read through GitHub - gnea/grbl: An open source, embedded, high performance g-code-parser and CNC milling controller written in...
BobCAD has a Grbl Post you can use: Post Processors [ATTACH]
Are you on the free licence? (Restriction applies to free version, post reimpliments G0s, unless feedrate is close to max rate of course then...
We do address several bugs (and some features, eg overriding the rapids limitations etc) so still better to use ours
Doesn't seem to be our post (or if it was, its very old, Grbl 0.9 dates back to 2015) Using the correct post should resolve, along with David's info
Current based stall would cause irrecoverable loss op position. If it was, it would not return to zero.
Torch mounted perfectly square? Torch cable suspended correctly (they are heavy and can tug on torch during moves?)
If you do, welcome! If you have any questions shoot them over any time! See the Docs at docs:blackbox-x32:start [OpenBuilds Documentation] and...
Also checkout Dr D Flo's [MEDIA] And make sure to get a LF inverter [MEDIA] Or [MEDIA]
If it is the screws itself. Motor wiring makes grinding noise too docs:blackbox-x32:faq-identify-motor-coils [OpenBuilds Documentation]
Doable, but can always splice further up away from the connector too. Use Wagos, 1-in-2-out lever terminals, Screw Terminals, splice connectors,...
No diagram yet. If its a belt drive machine with the Y motors facing each other then one motor is reversed.. If its leadscrews no reversal needed.
So the PWM port is directly connected to a GPIO pin on the ESP32. If the backfed voltage caused damage the ESP32 itself will be the victim....
We don't offer a repair service, sorry, but if you have any ideas what happened to it, we may be able to offer some insights on what it may take
It should be able to do both, so something else needs fixing: Hold the endmill and give it a wiggle - if you feel any play - follow the play by...
It has the look of mechanical slip. Most likely shaft coupler on leadscrew. The constrained slip is usually if the grubscrew isn't tight on the D...
Glad you already have them. Those aren't "ads" but just the normal startup splash screens. They change from time to time with seasonal greetings,...
Might you consider cutting off the Euro plug and installing a Nema6-50 plug to the end of the cable?...
In addition, the Product Tour pages lists all the available outputs and inputs. docs:blackbox-x32:layout [OpenBuilds Documentation] The bigger...
