Separate names with a comma.
Some features disabled for guests. Register Today.
Checkout BlackBox X32 Relays ?
Have you tested your power supply? What version of CONTROL are you on?
Not necessarily, but the store will help you check it out. Different team (:
One would be expected to be inside wifi coverage yes. But post #24 dealt with a customer with network issues, not the run of the mill :) context...
12-24v PSU > Stepper Driver > Stepper motor The driver converts PSU voltage to what the motor needs (a fixed current setpoint, so automatically...
Please contact the store via Support > New Ticket and we'd be happy to assist
Both issues point to VFD parameters needing more work. Min freq to protect spindle from too low RPM (and shut down when commanded to) as well as...
No issue as long as you grab the latest firmware
Click the Macros tab and create whatever custom tool you may need (:
Those do look a little worn down - I would replace them just to make sure it has another 3 trouble free years ahead. When fitting the new ones,...
Usually most lasers need external power. Your controller vendor should have their own documentation, but our OpenBuilds BlackBox's Laser...
Thanks for the suggestion, but continually checking continuity indicates some problem, you should be able to trust it. Why do you not have...
Wasn't developed by me, but I think I helped you customize it (beyond our standard expected service, so please note it might not happen again) -...
Not in CAM, in your Grbl Settings in CONTROL. The same place where you are supposed to set Laser Mode to Enabled? Which from your questions also...
Have a read through the Grbl Wiki: Grbl v1.1 Configuration Also check wiring
Dust is the least of the worries - oils degrade plastic/delrin/acrylic components! Always use Dry/PTFE lubricant Once a week is excessive though -...
Please contact the store via Support > New Ticket - including a link to this thread and they'd be happy to help you sort it out
Correct, you need to use a Grbl compatible CAM/Post: docs:software:overview [OpenBuilds Documentation]
Did you change $30 in Grbl Settings perhaps? (or it still 1000 default)
Did you follow all the setup steps in the BlackBox documentation (Particularly, make sure you didn't skip section 7.1?) If you did, please do...
