Separate names with a comma.
Some features disabled for guests. Register Today.
See Grbl v1.1 Configuration As its not our machine, we are unsure, but a teardown and investigation sounds in order. It shouldn't have that much...
If its NPN, it should work, provided you A) have the correct Grbl Settings ($5=? In your current Grbl Settings?) B) set the Limits V+ jumper to...
Comms issues points at Bluetooth then. Try direct USB cable. Also, genuine Uno, or $3 knockoff (some knockoffs uses inferior USB to Serial chips...
Speak to the friendly folks at CO2 Laser Tube | Light Object If its that old you might need to replace laser PSU as well so its all compatible,...
Yes, we do recommend our switches. Much easier to use with Hard Limits on both ends
Refer the documentation and note that we only support NPN type (yours is PNP)
Not likely no. But you could consider a small change in CAD or CAM workflow. Origin off front left corner, move drawing by entering accurate...
Origins are set in your CAM. Then in CONTROL you SetZero or Probe to tell the machine where the same origin that you used in CAM, is in the real...
Interface is Continous jogging only. For accurate stock origin setup, checkout docs.openbuilds.com/xyzprobe
Disable Soft Limits, or set the Z axis Max Travel larger. Probe being an unknown destination commands a move longer than you'd expect, which may...
Also check that you have $5=7 in Grbl Settings (For the X32 with our Xtension Limits) to ensure inversion is set correctly (as set by our profiles)
Hasn't been any changes, but 1) is your X32 firmware up to date (Section 7.1 of the BlackBox Documentation) 2) screenshots of serial log terminal...
Also check your Grbl settings ($6=1 for BlackBox X32, and $6=0 for BlackBox 4X)
Thanks for the feedback.
Thanks, providing this information, has helped indentify the bug, we have it fixed and released as V1.0.364 - see v1.0.364 ยท...
That is a very old ticket, and all we did there was to give folks with very old machines the option to disable the 3D viewer. Checkout GitHub...
That's not Interface (: that is OpenBuilds CONTROL Learn more about Interface on docs.openbuilds.com/interface As for the slowness issues, test...
Please post a screenshot of Devtools > Application > Local storage > 127.0.0.1 showing all the keys, so we can see
1) Never spin motors by hand while connected to a controller. They act like generators and backfeed the controller, which will damage your stepper...
I think so too, would possibly explain the overheating (Fault Indicator) (working harder than it should, if not dial it down a little) and likely...
