Separate names with a comma.
Some features disabled for guests. Register Today.
You'll ideally want to set it up so first run happens on boot - then its already waiting for you in the System tray (and its webserver and...
Initial startup puts it in the system tray, launch the UI from there
5min40sec+- shows limits wiring and installation 59min+- shows machine selection 1h00min20sec+- shows limit switch tick
Video embedded below [MEDIA]
1) install and wire switches as shown in the LEAD1010 Wiring and Software video 2) on Grbl Settings tab make sure you have Limit Switches...
Did you update the Blackbox Firmware as advised in the Blackbox X32 Documentation (Section 7.1 and 7.2)
Spin mounted endmill by hand, up against a reference (or dial indicator) and see if its offset?
Unable to stream the video, but twisting in Y beam usually means the bottom braces arent passing past the beams as shown in the assembly video.
(: who still uses Norton (: Probably just because its a self-hosted little script site on the grblHAL developers servers.
The Software does not. But Grbl has a Soft Limits option you have to look into
Did you check motor specs (inductance, resistance, etc)? If not, post a datasheet
Default config assigns the Door input as Abort yes. But when properly configured as a Door input you can fully control the behaviour. See the...
Probe dimensions on Interface is fixed to our Probe, not configurable. 3rd party / custom probes needs CONTROL
Random position could be EMI: docs:blackbox-x32:faq-emi [OpenBuilds Documentation] If you use CONTROL, we don't modify the GCODE so if it really...
Cutting (or a marker on the toolhead to draw one) a test square would be the best way to reliably confirm this - do it as big at the bed, and...
Thanks. The Gcode header doesn't contain any comments, out of which CAM is it? Which PC based host application do you use? OpenBuildsCONTROL or...
Perfect, see docs:xyzprobe:wiringgeneric [OpenBuilds Documentation]
We're here for you (: You'll get there
When using manual commands instead of the UI buttons and entry fields, its up to you the user to assert the correct modes. G90 vs G91, G20 vs G21...
Specs of the computer you are using?
