Separate names with a comma.
Some features disabled for guests. Register Today.
Motors not enabled: You have to load a machine profile (as shown in the LEAD1010 wiring and software video) CONTROL > Grbl Settings > Select a...
Ask a friend, or try a different computer You can't give up yet, if you are on Interface Firmware still, I bet you also haven't updated the...
When you were installing CONTROL it would have asked for firewall permission, you likely clicked Deny then Allowing an application through the...
Then as mentioned above: and also If it can't reach the Internet, it can't fill in the "version block" for you
If the PC has working internet, CONTROL will show the available Firmware version: [ATTACH] If not, allow CONTROL through the firewall, make sure...
V1.51 = Firmware version - you should update to V1.57 though, 1.51 is a bit old: docs:interface:firmware-update-control [OpenBuilds Documentation]...
Good catch, pulling it for now.
1) Try with all over wiring disconnected (Shorts in wiring?) 2) Try a different USB Cable 3) Try a different computer
If the Interface is still in a valid warranty period, you can contact the store via Support > New Ticket Otherwise you will need to order a new...
Yes. Plug in the old one > Grbl Settings tab > Backup Settings Plug in the new one > Grbl Settings tab > Restore Settings The backup/restore...
Contact the store via Support > New Ticket They would be able to advise
Refer the VFD manual and read it alongside docs.openbuilds.com > BlackBox X32 > 0-10v/VFD section. 0-10v is an industry standard. VFD manual will...
Those were our previous generation switches, still documented here docs:blackbox-x32:connect-micro-limit [OpenBuilds Documentation], but not...
Thanks for the report
You added the LASER toolhead in CAM. Go to CAM > Settings tab > Settings button and remove the M3 commands from the Start Gcode block
Not much. M3S1000 to turn on the Plasma (If $30=1000), and M5 to turn it off. Make sure your GCODE contains these commands at the right locations...
Did you perhaps accidentally enable Laser Mode in grbl settings?
At this time, its not customisable. Travel moves, by standard, are G0 moves that runs at the Machine's Max Rate (Grbl Settings) But we do...
CNCs need "paths" not cosmetic artwork. Your SVG has fill, stroke width etc (creates extra lines) rather than the expected path data - see...
Please continue your existing support thread via email with support.openbuilds.com - duplicate post between different platforms.
