Separate names with a comma.
Some features disabled for guests. Register Today.
We have a CUSTOM option in the list. But whatever is most similar is also a good starting point
Did you remember to load a machine profile from Grbl Settings tab > Select machine from list?
Intial state error indicates probe was already in contact. So possibly either EMI (false trigger) or calibration (bit was touching probe because...
Grbl Wiki > Interface Page lists the entire serial interface including errors and alarms
What controller and switches are you using? When testing, you actuate switches by hand. What happens if you gently jog into them (perhaps they...
Grbl 1.1 Jog command Grbl v1.1 Jogging to lift it up. We use that in our Probe Wizards too
I think its to test repeatability of his So I had this idea for a TLO probe...
This caught my eye That laststatus = may already contain current probe's data (depending on whether status or prbresult emitted first) I'd...
If you have the skills to do so... Our official recommendation would be to order a new BlackBox after checking all your wiring/accesories - to...
Have a read throught the docs while you wait - to get you prepared for the rewiring (:
Firmware doesn't just disappear - something happened to the electronics to prevent it from booting - usually electrical damage if nothing from the...
BlackBox - massive upgrade over an xPro: Learn more at docs:blackbox-x32:start [OpenBuilds Documentation] - 32 bit - Way stronger stepper drivers...
Power supply still good? xPro still good? It sounds like old / secondhand goods. V2 is a lot of years ago 10000mm/min might be a bit fast: Try...
Not quite, we'd say spacing the wires would probably get you a little closer. Also, don't go for "mechanical switches" - go for Xtensions Limits:...
You downloaded CONTROL, but did you go through the steps in the documentation to update the Firmware on the BlackBox too? Within 24h usually,...
Tested as working fine To test: XYZ Probe Auto · Issue #290 · OpenBuilds/OpenBuilds-CONTROL Tests fine: To test: XYZ Probe Auto · Issue #290 ·...
Tested myself against CONTROL V1.0.344 and a BlackBox X32 running the latest firmware (docs:blackbox-x32:firmware [OpenBuilds Documentation]) and...
Well, V1, V2 and Matte versions of the V3 all fall under $4=0
EMI is induced from noisy cabling (motors, spindle, mains) running in proximity to the low voltage signal cabling. Apply seperation. 12v power...
Sure its a V1? If so then 5. Troubleshooting states And you have So, if you are sure its a V1, that should be $4=0. ___ Changed from the Grbl...
