Separate names with a comma.
Some features disabled for guests. Register Today.
If its the 65mm body air cooled, no upgrade needed. Wiring the spindle via a Swing Arm helps a lot to seperate the noisy VFD wiring away from low...
Grbl Settings tab > Turn Homing Cycle back on
See docs:blackbox-4x:faq-identify-motor-coils [OpenBuilds Documentation] It's NOT that Gary, our factory default current setting is almost always...
Error 9 always accompanies an earlier alarm. Take a screenshot of the error (or read the Alarm message on the same window yourself) - we'd need...
For a very different machine (rigidity affect tool chatter which puts percussive loads on the endmill), and likely very different endmills....
Some of their models has an "offline controller" port [ATTACH] But we've not been able to locate a pinout or documentation (OpenBuilds releases...
Only if it runs Grbl and has UART pins: docs:interface:connect-generic [OpenBuilds Documentation]
Post your gcode file too - sounds almost like you don't have the CAM origin set to bottom left.
See above
Wizards and tools > Firmware Flashing tool will flash it for you. The BlackBox 4X runs standard Grbl, you can grab the hex from the grbl repo if...
Because its been already set up. You did skip a couple X32 setup steps, not quite a fair comparison. Got to update the old interface to know...
[ATTACH]
Could be a belt coupling to a 10mm leadscrew.
Non standard use case. So he'll have to recompile after configuring.
We've not got exactly what you need "ready to go" - its a odd use case after all, so see Home ยท grblHAL/core Wiki
Why not use G38.2 probing? Install a digitizing probe, and perhaps make use of a custom Macro Getting started with Javascript Macros in CONTROL /...
and You cannot update the Interface VIA the BlackBox. It's not COMPUTER > BlackBox > Interface :) Connect a USB cable to the Interface...
Can you clarify this section? Did you not yet update the Interface Firmware? It should be on V1.57 to work with the X32 1) Plug USB A-B Cable...
OpenBuildsCONTROL can be used with our controllers (docs:blackbox-x32:start [OpenBuilds Documentation] for example) or other controllers running...
Machine coordinates = negative space Work Coordinates = a mix, based on where you setup Origin
