Separate names with a comma.
Some features disabled for guests. Register Today.
It only goes into the hole for the AUTO sequence. So for now, enter the endmill diameter manually and use the XYZ Probe tab. Auto is just that...
While we wait for confirmation. Does any of the individual X, Y, Z probes also get stuck (A little slower, but at least gets you working for now)...
Ahh thanks. Passed it on to internal test team. Will let you know if they find a bug or not (:
Means some other application is still open and connected to it. For example if you had CONTROL open, and minimised it to tray while it was still...
That does indicate the PWM port on the BlackBox works, and the PWM signal is being generated (Correct commands sent from CONTROL, correct S-values...
Thanks, but they seem to have been scaled down in resolution, - hard to help you check wiring. Seems the white/brown out of the PWM plug goes into...
Please continue with the store, as advised above. Thanks.
You can send a Socket event like this: var data = { port: "COMxx", baud: 115200, type: "usb" }; socket.emit('connectTo', data);...
That would sound a lot less like luck - than something in motor wiring / psu / etc causing damage to the BlackBox - added a note to support team...
Please contact the store via Support > New ticket for that one
- I do see you are connected via Wifi - as a test - try connecting via USB - just to determine if that plays a role (if so we can dig deeper) -...
Then that would be $5=7 - so that is correct Upon triggering an endstop, it enters Hard Limits alarm mode. The Alarm window pops up giving your a...
What type of switches do you have? For ours the X32 needs $5=7
All the wiring. Laser side, psu, etc. We want to help you look for possible wiring mistakes
You use either the PC, or the Interface. Not both at the same time.
The 1515 already handles 4*8 sheets. Use the Tiling feature in CAMs like Vectric to process the job in half sections. Slide the sheet through for...
Post a backup of your Grbl Settings for review (CONTROL > Grbl Settings tab > Backup Settings button on the main toolbar) If its not that, its...
Don't need video, just a couple checks. Next up, copy of the log on the Serial Terminal tab, showing the probe operation.
OpenBuilds CONTROL > top toolbar has a Tool On button Purpose of this test is to see if its setup correctly (wiring etc) versus incorrect gcode.
What is "run mode" and have you done the tests using CONTROLs Tool On menu as requested?
