Separate names with a comma.
Some features disabled for guests. Register Today.
Passing on for sure. These kinds of messages are read out to the team in the morning meetings and really means a lot to the team members. Have a...
Adding '--before default_reset' might help? We use the standard nodemcu autoreset circuit that pulls down IO0 during flashing too. [IMG]
Standard tooling is good. But yeah, we are friendly enough to save people who forget to backup too. Latest is always best though as we'll be...
Also always available on git: History for grblhal-grbl3axis.bin - OpenBuilds/OpenBuilds-CONTROL If the Run/Flash jumper is in the Flash position...
Loss of position on a belt driven machine - first thing to check = Grubscrews on the pulleys!
Angry sounding motors could be wiring: docs:blackbox-x32:faq-identify-motor-coils [OpenBuilds Documentation]
Accurate moves working 100% first, before relying on the Probe yes
130 *25.4 = 3302mm/min - pretty close the Max Rate value in our default 1515 profile: [ATTACH] Max Rate is explained here: Grbl v1.1...
Updates are always welcome! It really does help others Yes, overload trips are usually VFD parameters, or forgetting to set Minimum Freq (most...
We use 1/8th microstepping driver - so that number is probably off. Use the Calibration Wizards in CONTROL: [MEDIA]
Folks over on the Library's issues has located EXAM1: BOSSEN_USB_FOR_WT/Documents/EVT/EXAM/EXAM1 at master ยท changleo828/BOSSEN_USB_FOR_WT but no...
Not at the moment no, sorry :(
Are you on Firmware 1.57, we've added some power saving to later firmware versions. You can also apply docs:interface:retrofit-x32 [OpenBuilds...
To determine if its a VFD or BlackBox issue: 1) Disconnect VFD from BlackBox 2) Connect multimeter in voltmeter mode to 0-10v output 3) Send...
Trial and error (: if you see it bogging down, jump on the Feedrate override slider
The basic rule of thumb is to cut as deep - as half the endmill diameter per pass. For a 1/4" endmill, run 1/8" deep per pass. You can run nice...
Wifi is good, but something in your network is not playing nicely. I can't directly help with that. We have about 15 odd BlackBoxes in the three...
from that screenshot you can see the left side of your job exceeding the cube representing the Machine Envelope. So still good call on disabling...
