Separate names with a comma.
Some features disabled for guests. Register Today.
Did you click the link? First section deals with short circuits, possible permanent damage etc - which from the sound of things are the likely...
Even better, in CONTROL > backup the settings from old controller using CONTROL > Grbl Settings tab > Backup settings button. Then plug in the...
You don't "need" them but they are always a nice upgrade to dial out wear and tear that develops later on
This is the FAQ page docs:blackbox-x32:faq-usb-connection-failed [OpenBuilds Documentation] Work through it step by step
@RonBKnox is 100% correct. See section 7.1 and 7.2 the docs instructions: docs:blackbox-x32:firmware [OpenBuilds Documentation] changelog :...
G28 is a "stored position" not Home refer to G Codes You should home on power up and after any event that could make it lose reference (alarms,...
Refer the same FAQ page mentioned in the error log onscreen
X32 is $4=0 as set by our profiles
G28 isn't home Soft limits uses machine coordinates, so you have to Home. Homing command is $H
Please contact the store via Support > New Ticket Thanks
Just stating as a reminder. One typically (at least you should) turn off power while working on it, only powering up to test to avoid shorts. You...
This 24v PSU also powers the 10v system docs:blackbox-x32:connect-psu [OpenBuilds Documentation] so make sure its ON and BlackBox power switch too
You mentioned earlier: So then where were you getting it? Or it was working and since stopped? Also, make sure you didn't forget to turn on the...
Well, again confusing as there are two places: VFD parameters yes usually 400Hz Grbl Settings - again, don't go randomly changing settings (: -...
So confirm, you are getting 10v out of THAT connector (yes or no?) the plug in the picture labelled 0-10v - when setting spindle speed to 100%...
The picture in the docs shows exactly what to do: [ATTACH] Make sure to look at the Blackbox X32 docs. Not the Old 4X's docs. The 4X had a...
ONLY the 0-10 output should show (as labelled) up to 10V The other pins (Enable, PWM, etc) are 3.3v logic pins. They have OTHER uses (like Diode...
Refer to docs.openbuilds.com and do things right. Random "lets try the nonstandard thing" may lead to a damaged blackbox. The other outputs are...
That's not the tool head pins. But the 0-10v output. Seperate plugs. Be specific about which you are working with
That is in spec. Its a n 3.3v system
