Separate names with a comma.
Some features disabled for guests. Register Today.
Setting up the full dev environment can be tricky, but last time I set up mine, the documentation did work. I'll compile what you need on Monday...
Acceleration is set quite low too: $120=10.000 ; X-axis acceleration, mm/sec^2 $121=10.000 ; Y-axis acceleration, mm/sec^2 $122=10.000 ;...
There is, but if (as the person earlier in the thread) the EMI is introduced into the cable, you need the cap and pullup near the Controller side.
Filters are built into the Blackbox, not the Probe. Noise is on the wire, so no use filtering on the far end, the controller should clean up the...
Plasma not VFD would be a different story yes. Drop us a ticket via Support > New Ticket - have a Beta firmware image we'd like you to help test...
- Do you have any custom macros? - Did you change the Theme between screenshot 1 and 2? Or does that happen automatically - Is this the original...
You can definately re-use some of the components: electronics motors C-Beam Endplates Router Mount Corner connectors The electronics makes the...
Use a regular endmill (or even better a precision gage pin https://www.grainger.com/product/VERMONT-GAGE-Class-ZZ-No-Go-Pin-Gauge-0-5VUG0 ) to...
Highly recommended to fix the machine config as other CAMs also expects the machine to follow "CNC" standards (positive quadrant is for additive...
Line 17: G53 G00 Z0.0 - moves in Machine Coordinates (not work Coordinates) so make sure your Machine Coordinates are properly defined. Grbl...
With VFD properly configured (Min Freq) the 0-10V input will keep the VFD off (it needs both to spin up). Forgetting to set Min Freq may make...
Correct, you can just invert the behaviour using "$16= ;Spindle pins invert, mask" in Grbl Settings to correct. $16=1 if I am not mistaken...
We list our recommended CAMs in the link above
Don't catch on fire (: - also known as "what happens when you leave CNC unattended" [pics]
Checkout docs:software:overview [OpenBuilds Documentation] - more advanced CAMs output Arcs, the free and entry level OpenBuildsCAM does not, for...
Contact the store via Support > New Ticket for assistance
Do the checks first to confirm it is the case, but if it is - couple possible reasons: - a terminal left slightly loose and wire pulled out...
1) home before zeroing 2) zero as usual 3) When you come back, JUST HOME (do not set zero again) - offsets from last zero is stored in EEPROM, all...
After completing the Probing operation, remove the Probe, and hit GOTOZERO to move the Endmill to where Zero was set. In CONTROL 0,0,0 is also...
Try a Linux install in between reinstalling Windows (if it does not help) and getting a new PC too - sometime Linux drivers plays nicer on older...
