Separate names with a comma.
Some features disabled for guests. Register Today.
Please contact the store via Support for further assistance (: - they will help you diagnose the root cause as to what that pole may be...
Clip the magnet to the collet nut for better contact. Diameter = diameter of the part of the bit touching the plate XYZ Zero is consistently...
Selling onward a (still working) machine that doesn't fit your needs, and putting that toward a LEAD1010 makes a lot of sense once you think about...
Get a BlackBox and some of our Xtension Limits. Use our Software too :) so the above advice can apply. Learn more on docs.openbuilds.com about...
6mm for Outside cuts. So the edge of the bit runs the profile
Your DXF has the part drawn in the negative offset - there is an origin in your sketch as well. If you set it bottom left, your drawing will be...
Thats not how digital data works :) You can wire your motors the wrong way round (but that would also be consistent irrespective of the host...
Always refer to docs.openbuilds.com Fusion Post is here: docs:software:fusion360 [OpenBuilds Documentation] Don't forget to Home properly before...
QCAD does a great job for free : Problems with importing DXF into OBcam
Interface just send serial data.
Convert all the different types of entities in the DXF to Polylines: see docs:software:file-errors [OpenBuilds Documentation]
If it works right on the PC, and you go to the interface it will work right too. Just jog straight away. If it has random direction changes etc...
Homing failure is almost always wiring related. Sometimes Grbl parameter related. Use the Troubleshooting tab in CONTROL to test the switches...
CONTROL and INTERFACE boths sends the same commands. Random direction changes may be wiring, see the Symptoms section of...
Check that you remembered to unplug the USB cable - you can only use USB or AUX, not both. USB takes preference. See docs.openbuilds.com/interface...
Then your controller is either fried, or doesn't run Grbl 1.1
You weren't trying to connect (button on main toolbar) according to your Screenshot. You were trying to Reflash firmware (from Wizards and Tools)
The device descriptor in the Ports menu tells you a lot too. Get a Genuine Arduino, or a BlackBox (see https://docs.openbuilds.com/blackbox)...
See docs:blackbox:faq-emi [OpenBuilds Documentation]
Please contact the OpenBuilds Partstore via Support for assistance
