Separate names with a comma.
Some features disabled for guests. Register Today.
It's tricky, size itself isn't the issue. So, basically our entire ecosystem is painfully engineered to all work really well together. Our motors...
That is a big heavy piece of metal to spin up, so yes, will slow you down - you'd need lower acceleration just to overcome the weight of the...
Looks like loose setscrews on shaft couplers (:
Yes, any loose wheels, loose stop collars, loose fastners, any unwanted movement can cause additional chatter
No the Z axis would have up and down bumps. This is in X or Y
Might it be that during the reassembly work, you knocked out your tramming? Possibly with the X+ side of the gantry lower than the other causing...
The pronounced step at around 5'o-clock on the circle indicates something loose. Stop collars not tight up against the bearings or a slipping...
Yes, similar enough
We never have :) checkout the descriptions on the Videos and the older social media posts, we have always linked to OPT Laser's website so you can...
Which wheels were you using? Xtreme (PC) or regular black ones (Delrin) Cracking is usually a combination of overly tight eccentrics, or dirt in...
Turn off translation in your browser and try again. Only English is supported, automatic translation may cause the site not to work correctly. If...
Use the Wizards and Tools > Calibration menu
Also, check the Troubleshooting tab and make sure the CORRECT AXIS for each lights up, accidentally crossing X and Z wiring for example will also...
Ps, was mentioned in the Docs :) docs:blackbox:connect-rc-servo [OpenBuilds Documentation] Best to have pen only under gravity. Servos "self...
Yes, photos would help confirm of its slippage (more pronounced stepping during direction changes for example) or calibration Also let them check...
Contact the Partstore at support.openbuilds.com for assistance with that issue, thank you :)
Servos are analog devices, so, yes the cheaper ones can be weird. It doesn't remember per se, but will move where commanded next time.
Yes, if you tighten them too much they will wear grooves into the wheels. Eccentrics are for taking out slack, not tightening. Just turn until the...
Are you running an older build of the Firmware? See INTERFACE CNC Touch Controller
Also checkout High Z Mod for Lead CNC > post about repurposing it for Workbee use That second rail does a lot to increase rigidity
