Separate names with a comma.
Some features disabled for guests. Register Today.
You can terminate your gcode strings with a newline ("\n") just for sanity Have you tested that you can move it from a known working host like...
Correct the most (axis+) position (jog as far as the + button take you) For Z thats where the bit is Up and furthest away from the stock. Have...
Indeed. And if you follow the standard (Install at top of the Z axis - or at least such that RAISING the Z axis triggers the switch, Right and...
"Home" (Machine Coordinates G53 X0 Y0 Z0) is (by default) Top, Back and Right (Axis Maximas) : See Frequently Asked Questions ยท gnea/grbl Wiki...
No, you need Switches to Home. You can "fake the home" but its such a schlepp and unreliable. Get the switches installed, it will change your...
For sure, Servo support is tied right in: docs:blackbox:connect-rc-servo [OpenBuilds Documentation] and the recommended way to raise a pen.
Correct, as the surfacing wizard does add the offset for the endmill diameter Negative, you can only set Work Coordinates. Homing sets machine...
And being a modular system, we tend to rather have two parts that can be put together to make one part, so you can use both on their own too: So,...
I think 1540 is the maximum, but as always, Part/shipping queries are better directed at the Store team directly - they are more on top of it:...
Negative, those are Unipolar motors. Also, very very low current. BlackBox is for Bipolar motors, with at least 1.3A rating. Those little 28s are...
The several millimeter is half endmill diameter to ensure the resulting surface area matches what you entered, by moving inside this area only...
Please contact the store via Support for assistance (:
Careful! Wiring a load to a signal pin, can damage the signal pin! You'd need a drive circuit in between to convert the 5v logic signal to a...
Get in touch with the store via Support for further assistance
See docs:blackbox:currentadjustment [OpenBuilds Documentation] for a description of the causes that trigger the Fault monitor and turn on the LED
If it only errors when you connect the motor: See docs:blackbox:currentadjustment [OpenBuilds Documentation] Fault raised by the motor (pulling...
At least 100k - that's at least 100,000 times that it can be changed from one mode to the other (not times you send the command, if that bit...
Unfortunately not, the thinner Motor Mount plates are needed on that side too, for the stack-up to fit on the leadscrew - if you were using the...
We don't currently have the ability to tab on non-straight sections but if you experiment with Tab Width and spacing enough you may get lucky, you...
Or just setup your CAM toolchains to include $32=1 in laser jobs and $32=0 in non-laser jobs, then you don't have to be involved at all (: For...
