Separate names with a comma.
Some features disabled for guests. Register Today.
We have ours only in 1.8 deg. Amazon specs are hard to find for sure. The theoretical resolution doubling of 0.9deg motors are very impractical...
Forward/backward tilt: adjust top or bottom X rails in and out a little (Corner brackets has play) or adjust the Z uprights Left/right tilt:...
Did you spec them correctly? If they are low current motors, BlackBox has a 1.2-1.3A minimum (ideal for 1.7A motors, as you don't want to run...
Is it an OpenBuilds machine, or from a 3rd party supplier?
While I do see your point, the refreshing is not a normal part of the workflow - fixing the network would make it perform "as designed". Will...
TinkerCAD is pretty beginner friendly: [MEDIA]
No, clear. But at 10600um wavelengths it is opaque (absorbs/blocks IR light)
Acrylic is opaque to 10600um light, thus why it can be cut - it absorbs the light at that frequency quite well. Many machines just use a 1/4"...
You didn't mention that, so had to assume you were still using the same file... The error messages shows the line that caused the error - so can't...
Add an Earth to the router
Check for stress and strain points - using cable chains and tying off any strain points with cable ties to prevent tight-radius bends, and...
The BlackBox does not have anything to do with Flashdrives, so I think you mean your OpenBuilds Interface? Contact the store at Support for...
See docs:blackbox:start [OpenBuilds Documentation] > Sections 3.3.2 and 3.3.3 for the generic connections. For specific of your laser module,...
You HOME to establish Machine Coordinates Then you ZERO to tell the machine where the origin of the Stock is (Work Coordinates) You set the...
Here is the questions you havent answered several of us trying to help you, summarised again: Sitting down, focussing on the questions, and...
Then download CONTROL from software.openbuilds.com Read the BlackBox Documentation at docs.openbuilds.com/blackbox And read the Grbl...
Warranty still valid
Regarding PS: that would be a mistake in the GCODE indeed! Good catch. We echo the line sent, (Grbl doesn't have Echo on by default, so the...
