Separate names with a comma.
Some features disabled for guests. Register Today.
Agreed - Definately start by not using Easel (Not our software after all) and rather use our Hello World as a basic, proven, test to work out the...
Available here: Tension Nut (Nut) Thrust Bearing (Thrust Bearings) C-Beam Motor Mount Plate (Replacement plates)
Not for the Uno, with the Interface we are powering the Interface off the same rails, so the ICSP board helps filter any spikes from that. Your...
Best to contact the vendor you purchased the controller from for tech support. Thanks
Please contact the vendor you purchased your controller from for tech support. We use the BlackBox: docs.openbuilds.com/blackbox (:
Nope, its a Ooznest Ox Does it have BlackBox or a Duet as controller?
What version of BlackBox do you have? V2.3-2.7: May, may need to prep it first: see section 2.1.1 of docs.openbuilds.com/interface to get the Aux...
We wouldn't recommend it - but look into HSM/Adaptive stategies with 1/4" tooling. Moving faster, gets more done - without needing bigger tooling....
See the above link. Lots of other things to try other than Ferrites. Ferrites can suppress noise, but its much better to eliminate the source of...
If it was close enough to 8mm, see 3GT (GT2-3M) Timing Pulley - 20 Tooth - 9mm Belt - 8mm Clamp Bore - for other sizes you will need to source...
Depends on the setup and CAM The right way is to leave a little stock, and CAM up a finishing pass properly. Rerunning it may work - but less...
Generic reply, but should cover it: - play with speeds and feeds and other cut parameters - something might just be a little off - try a different...
Best to enquire about shipments directly from the store to get it resolved soonest. Speak to them via the New Ticket option on Support
Thicker is always going to be stronger. Its up to you what compromises you are still going to be happy with.
Check your Spam folder too, store usually replies within minutes. They probably will send out the missing parts too - we are quite known for our...
Best to contact the store directly by opening a ticket on support.openbuilds.com
That may increase the leverage of the sideways cutting forces against your Z axis, causing extra deflection
Its more likely mechanical... You cannot calibrate individually.
Thanks for the notes :thumbsup:
Ox? or Workbee? Those are two different machines. We also never offered a 1500x1500 Workbee, from where is the machine? What controller are you...
