Separate names with a comma.
Some features disabled for guests. Register Today.
Is the plywood of a suitable grade? The $20/sheet stuff around here is held together barely, and has massive voids flooded with resin. Cutting...
You want a pen holder than can compensate for any uneven surface (gravity or spring powered, lifted off the surface between moves by servo) The...
See gnea/grbl and docs:software:lightburn [OpenBuilds Documentation]
Your user a account is denied access to the serial port because it doesnt have permissions. Usually either needs user account added to the...
Typo in URL. I am moving this weekend, checking forum off phone, so, oops and sorry. Miss my desktop keyboard i guess. Edited original thread you...
The OpenBuilds system is modular (like Lego or Mechanno) - browse the store and build it up in your mind or (better) in CAD. Alternatively...
Absolutely, the store handles custom cuts and orders. Go to the OpenBuilds Partstore's Support page and create a new Support Ticket - they will...
Our software only support Grbl 1.1 based controllers: gnea/grbl Consider replacing your controller with a BlackBox : See...
It derives the 5v off the USB, and after the schottkey diode its dropped to around 4.8v average - dropping to 4.5 after wiring is about right....
Disconnect your Enable wire - drivers are enabled by default, but maybe gets "disabled" by incorrect inversion on enable signal - disconnecting...
COM1 is the motherboards onboard serial port, not the BlackBox, thus it cannot connect to it See the BlackBox Documentation > Install Device...
Is your drivers compatible with 3.3v signalling. Most of that format of drivers need 5v signals.
Properly adjusted V-Wheels have zero play, as you preload the wheels against the extrusion. We use eccentric spacers to adjust the wheel spacing...
There are EEPROM reset buttons on the top toolbar of the Grrbl Settings tab that can clear it all for you
Try disabling the 3D view and other performance using features from the Troubleshooting tab > Application Diagnostics menu to see if it runs a bit...
Same principle applies :) - NEMAxx is just the physical mounting pattern (where the screw holes are located, and some basic face dimensions)...
G0 happens at Max Rate, so you are probably still stalling because you haven't got properly tuned Max Rate/Acceleration: See gnea/grbl Some hosts...
