Separate names with a comma.
Some features disabled for guests. Register Today.
Succesful upgrade yes. If it says 1.1g, you picked one of the other options in the list. If you wanted to flash the hex, you can use the Custom...
There are quite a few: =38']Search Results for Query: blackbox co2 | OpenBuilds Yes! Safest way! Easy Peasy :) : See Advice on CO2 Laser Build...
Most importantly: the most expensive, rated for CO2 laser wavelengths, correct OD rating - protection goggles you can get. Replacement corneas are...
You'd have to upgrade Grbl on the xPro to grbl 1.1 to get Grbl v1.1 Laser Mode · gnea/grbl Wiki so you can use docs:software:lightburn [OpenBuilds...
We build againt Node 12 on Github Actions these days: OpenBuilds-CONTROL/build.yml at master · OpenBuilds/OpenBuilds-CONTROL - assuming official...
I'd think it's unlikely, but a stripdown is the only real way to check. May rather be: - slightly loose setscrew on shaft coupler/pulley causing...
If you are unsure if you have a dead 5V regulator, check which LEDs are on on the BlackBox with, and without USB. If the RGB LED, 5VOK, Front...
You plug it into X or Y and use "Wrapping" : see Rotary Machining and Wrapping - Aspire V9.5 User Guide As demonstrated in the LEAD Lathe project
Check you Grbl Settings, Max Rate. Not your CAM parameters. See Grbl v1.1 Configuration · gnea/grbl Wiki as G0 moves run at that rate, not you cam...
Sorry, see section 7 of Terms of Service and Rules | OpenBuilds
The straight line runaways do look like EMI: see docs:blackbox:faq-emi [OpenBuilds Documentation] But do rule out as well: - acceleration and max...
Checkout the https://docs.openbuilds.com/blackbox
With a router, turns on at start of job and off at end. Otherwise you have to do that manually With spindles, turn on/off but can also control...
Have a read through Grbl’s very detailed documentation Wiki: Home · gnea/grbl Wiki
OpenBuildsCAM doesn't support Arcs, so, use a more advanced CAM. But per-se "not-an-arc" isn't always the cause though, provided the line segments...
Looks like it. BB > Spindle controller > Spindle. Although on some of these there is a jumper to switch to between Potentiometer and 0-10v...
OpenBuildsCONTROL > Grbl Settings tab > Click the Backup Settings button on the top toolbar and post your Grbl Settings backup in a reply (just a...
None, as its not an intended use case of OpenBuilds CAM - its a very entry level, get you started tool. For more advanced work, use a more...
Adding on to Sharmstr's reply: See Grbl v1.1 Configuration · gnea/grbl Wiki - the Grbl wiki is a must read (;
Not at this time, zero on your spoilboard/cutting mat, so it knows how deep to cut (all the way down to spoilboard/cutting mat)
