Separate names with a comma.
Some features disabled for guests. Register Today.
Like so: [ATTACH]
You shouldn't include the library to a sketch. Use the correct method (Files > Examples > Grbl > GrblUpload) as described in step 4: Compiling...
Also consider the Acro: Machine Bundles - ACRO System - OpenBuilds Part Store and Checkout our YouTube channel for videos: Several XY table...
Then you can approach Protoneer for support and I am sure he has documentation for the boards too, showing the pinouts. The fakes has it wrong,...
As it doesn't have a Z axis, and Z homes first. See Frequently Asked Questions · gnea/grbl Wiki to recompile without Z axis homing Normal, if...
Despite the different controller, probably still either: 1) loose setscrews on a shaft coupler / other mechanical issue or assembly error Or 2)...
I'd suggest leaving a little of the Spoilboard open, then incorporate the vertical clamping setup from the table underneath
Not at this time, but thank you for the suggestion
The built-in wizard in CONTROL has a hard-coded 10mm clearance Use the Gcode editor tab to find/replace the "G0 Z10" lines with something less
Still good to cross off the basics. Run a couple air-cuts and see if you can reproduce the issue
it should, see docs:xyzprobe:wiringgeneric [OpenBuilds Documentation] For probing gcodes see G Codes we use G38.2 in our software: javascript...
OK OK (: - rephrasing: You cannot automate your way around every possible point of failure, without endless budget and time constraints, but we...
Did the error pop up right after starting the spindle? If so: spindle creates EMI. EMi created a false limit switch trigger. Limits wiring too...
Acceleration/Max Rate tuning required. Process is described in the Grbl Wiki: See Grbl v1.1 Configuration · gnea/grbl Wiki and...
As its not an OpenBuilds product, best would be to ask the Seller you purchased it from for Tech support for their product. Good luck
Alrighty then :) PS: You might still be able to get a BlackBox, just speak to the store (this is the forum, different staff from the Store) at...
if its the Xcarve controller, it does not have a Serial UART, so just double check that
Checkout the BlackBox documentation at https://docs.openbuilds.com/blackbox - as tech support and clear documentation surely should help with the...
Its possible yes, that your laser has a low quality driver that doesnt turn on that low. Test it on the PC side by running a test job at 2% power?
Driver is section 4.1, dont skip 4.2 or windows power management will shutdown your USB portd mid-cut at some point. Read the documentation...
