Separate names with a comma.
Some features disabled for guests. Register Today.
Hello all, thanks for taking the time to help me with what I hope is a straightforward project. My goal is just to move a lightweight object along...
Hey! I have a question ^^ I am currently working on a 3D printer/CNC machine/laser plotter (cutter). I would like to use linear rails for the...
In following the video, all was good until I tried to attach my NEMA 17 stepper motor (not supplied by OpenBuilds) to the end plate. After...
I have built a cnc with Nema 17 motors. it is controlled by an Openbuild Blackbox. with the external adjustment of volts for the motors. but...
Hello all, Please correct me if I am wrong, but I do not see a stock way to mount a Nema 17 onto a C-Beam XL gantry plate to utilize the belt and...
I am currently using the Raspberry Pi CNC Hat (2.6) to drive a 40x40in ACRO Laser etcher (OpenBuilds ACRO 1010 40" x 40") So far it works great!...
Hi, I have a nema 17 attached to a mount running off of an arduino uno using a tb6600 stepper driver. The motor will operate just fine up to...
Dear all, I have set up a 2 axis rig with two paired stepper motors for the Y-axis and an isolated motor for the X-Axis. all of them are driven by...
I have a 2015 xcarve. getting rid of the Arduino and gshield. I like the blackbox design and instruction. I also just purchased the power source....
Hi All, I have an Acro 1510 that I recently set up and the steppers get quite hot after an hour of use. How hot? >> about as hot as a mug...
First time putting together a CNC machine, got all my parts from OpenBuilds and have a quick question, any advice or googling instructions...
Hi there, I am working on my very first 3D printer build! I'm pretty excited, but also lack a lot of knowledge in the area. My build is going to...
I recently bought a C beam CNC machine with 3 axes (c beam linear actuators). I am planning to attach an additional linear actuator to my z axis...
Hi All. My ques is very basic ... I want to connect a Tripod Screw (1/4" UNC) with a NMEA 17 (5mm Bore) Motor Shaft. I am looking for a rigid...
Well not wrong, but for me the Nema wires are different colours to mine. The Colours on the diagram are, RED GREEN YELLOW BLACK Now my Nema 17...
My parts arrived for the OpenBuilds parts store and looking at the specs I'm not sure if I could/should run my Nema 17 with the same power supply...
Hey I'm having a few issues with my laser cutter and if anyone can help me solve any of these I would be very grateful. So just to start off,...
