Separate names with a comma.
Some features disabled for guests. Register Today.
I need to control a Nema 42 with the BlackBox x32 to get a higher torque. The power requirements are 6A & 4.8V. Any recommendations for a driver...
New to this forum. Thought I would post some issues I’m having with my JD’s garage cnc plasma cutter so see if I can get some help. I’ve been...
Hi, I’m new to working with stepper motors and drivers. I have two 24V-0.3A stepper motors and two drivers, but only one 24V-1A AC to DC power...
I'm just getting into stepper motors and was looking at the best way to control one with a PLC. Do I need a stepper driver or would Openworlds...
Hi, I'm new to the community and to cnc. I have a knockoff lead cnc kit that I'm putting together and I'm trying to figure out my movement. Motion...
Hi, I’m not sure about the dip switch settings on the DQ542MA stepper driver, regarding the Amps settings for the motor. My motors are the NEMA23...
First time putting together a CNC machine, got all my parts from OpenBuilds and have a quick question, any advice or googling instructions...
Arduino based build with TB6600 drivers and NEMA 23's. I finally got some motion on my machine, but when I prompt it to jog in UGS, the motors...
Hey guys, let me start saying that I'm a total newbie in electronics and CNC machines. I'm building a CNC laser cutter. I'm using Chinese...
I have set up the OPENBUILDS ACRO 1510 and controlling it via an Arduino Mega board. The two long rails each have a motor mounted on the ends of...
Hey folks, I've been working on upgrading my earlier version of motion controller and the motionPro 6600 is the result of that. I have to thank...
i'm not sure what happened but i think i shorted one of my stepper drivers, I was testing the motors and a usb cable fell on top of some pins and...
I recently bought and assembled the C-Beam machine. I took it outside to do first cuts earlier this morning and much fo my dismay ended up with...
Hi all, this is my first time setting up a CNC router. I have the OX CNC with Nema23 steppers and the CNC shield paired to GRBL running V1.1....
Hey all, I'm working on a project and have come to the point where I need to use two stepper motors to drive lead screws to lift a Z axis gantry...
Hey, all. I've been continually tweaking and using my Ox derivative "Cebu" All has been working well, for the most part, especially since...
I've purchased four brand new, never used, not even wired up Nema 23 Stepper motors (~$25). What I needed were the High Torque Series Nema 23...
Hello everyone, I've been developing a hbot machine for a while now and I'm having problems with my electronics. Specifically, my xy motors that...
Hi, I am new here, and trying to figure out which stepper driver I should use with a MK2 (or MK3) 9 axis controller. Motors are: NEMA 23 Peak...
Hi guys, this looks like a lot of fun. I found grbl and tinyg after watching NYC CNC on youtube and I'm excited to get mine working. Question is...
