Some features disabled for guests. Register Today.

thc

Thread
Plasma table Touch off - HELP!!!

Hello Everyone, I'm Back!! I have learned a lot since my last post. Except how to set up touch off on my plasma table. I have searched (what i...

Thread by: BrandonLebrun, Mar 20, 2024, 2 replies, in forum: OpenBuilds Forum Help
Thread
How to interface Proma SD to BlackBox Motion Control System

Hello I have managed to interface Proma SD for THC to BlackBox Motion Control System with successful results. If there is interest I can describe...

Thread by: Bengt Carlsson, Sep 13, 2021, 7 replies, in forum: General Talk
Thread
Best controller board that allows me to use Torch height control? (THC)

Starting into the research phase of building a CNC plasma cutter. Would really like to get torch height control and I have seen some controllers...

Thread by: joetemus, Sep 1, 2019, 1 replies, in forum: Laser Cutters
Thread
Plasma Cutter on an ACRO & Blackboard - THC & other issues.

I want to build a CNC plasma table based on the Acro + Blackbox + NEMA 17 motors. Size should be 750x1000 or 1000x1000, didn´t decide yet. Could...

Thread by: Jay Riffs, May 27, 2019, 10 replies, in forum: Laser Cutters

Showing results 1 to 4 of 4

This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.

Accept Learn More...

Dismiss Notice