Separate names with a comma.
Some features disabled for guests. Register Today.
I m brand new with my blackbox x32. I got a upgraded x carve machine. My problem is when I use the xyz probe my y axis always go to the middle...
Hi and thank for your help. I had my own XYZ probe machined. I used it a couple of times as Z-probe only and I manged to do the custom setup. I...
Greetings, New OpenBuilds XYZ Probe owner here. I've testing with a piece of 2x4 firmly attached to my bed with tape and CA glue. The weight of...
I have query about the XYZ Probe. My probe works okay but the LED lights are on all the time. This is not the case in your videos - the LEDs only...
Just assembling the Openbuilds XYZ probe, and have fallen at the first hurdle. The L-shaped circuit board does not fit. The connector wiring box...
Hey Everyone, I finally got my lead 1515 machine up and running and wanted to run a quick test to check the tramming of my router. I mocked up a...
Hey guys, I am experiencing an issue when I try to use my XYZ probe that I purchased from open builds. Here's my setup: - Open builds nema 23...
This is a simple holder for your xyz probe. I printed this standing up, I did use supports but that is probably not necessary. There are two...
Hi I am running a Black Box, Open Builds Interface and the XYZ Probe Plus. I Home the machine and it works as it should work, No problems...
Hi I have been using my touch probe plus quite happily until today running the XYZ probe wizard usually works fine but today the Z axis probe...
When it works its great, but I have broken about 4 bits now when the Z will not register. So maybe i'm doing something wrong or there is an issue...
Machine is a ball screw machine self designed. Controller - Black Box, Software Openbuilds Machine controller, Probe XYZ (open builds). Was using...
I've connected and tried the XYZ probe form open builds, and I've got a question. It appears to work, but it does not seem to take into account...
I needed an XYZ probe for my experiments on creating pauses in an nc file to allow toolchanges to work. I haven't got around to milling aluminium...
