Separate names with a comma.
Some features disabled for guests. Register Today.
I m brand new with my blackbox x32. I got a upgraded x carve machine. My problem is when I use the xyz probe my y axis always go to the middle...
Hey all, I ran into an issue with my 1515 lead cnc machine... I finished the setup and powered my machine, but soon found out only one Y axis...
Using an Open Builds LEAD 1010 fully loaded with an Blackbox x4. Used troubleshooting page to help diagnose... The wire as of right now has...
Hello! Today i set up my 1515 and so far it is looking good. But now i have one thing to do and that is squaring my Y-axis so both gantries are on...
Hello all, I finished assembling my Lead 1515 yesterday and when I got to the point of jogging the x and y positions I ran into an issue. Here...
I just completed building my second 1515 machine and am running into an issue where when I run my gantry all the way to the back, the right side...
Hi, I have a Openbuilds 1050 been working great for a few years now. But now the left side of my Y is not moving the same pace (dragging) as my...
Hi All, I have an XCarve (post 2016-xcontroller) 1000mm and the max carving size is 750x750mm..i see people have ungraded the axis using...
My cnc openbuilds workbee 1000mm x 1500mm, with board gShield v5b - systhetos + arduino uno (original) Y axis = 2 trapezoid screw Z-axis =...
:(hi all I’m after a bit of help. I’ve made a combined edge probe and touch plate for my cnc. Connected the positive to the plate and negative to...
I just finished the build for the OOZnest 1500x1500. The X & Z axis worked perfectly from the start. I am however having problems with the Y axis....
Hi everyone, hope you are doing great! I have finish my first ox cnc 1500x1500mm and wired it but i have problem with my y and x axis. It seams...