Welcome to Our Community

Some features disabled for guests. Register Today.

Any way to start the surfacing operation from the 0 position?

Discussion in 'CNC Mills/Routers' started by DementorLM, May 1, 2022.

  1. DementorLM

    Builder

    Joined:
    Mar 3, 2022
    Messages:
    11
    Likes Received:
    4
    Hello all,

    I surfaced my spoilboard today on my Lead 1515, but when I started the job it did not start exactly from the zero position. I lost a total of almost 2" on the X axis and 1.5" on the Y axis. I measured it and my X axis working area measures 46" and my Y axis 51". I use 48" x 48" material and I am afraid this will cause problems.

    Should I just grind down the sides by hand or is there a way to start the job exactly at the 0 position using the Surfacing Wizard? I attached my Surfacing settings, but during the job I noticed both the X & Y axis never reached those values. (X 1175mm & Y 1300mm).

    Thank you
     

    Attached Files:

  2. sharmstr

    sharmstr OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 23, 2018
    Messages:
    2,059
    Likes Received:
    1,448
    Yeah it does a pocketing operation. Meaning it will offset the radius of the bit. That caught me once. Now, after I run the wizard, I jog to cut the excess.
     
    DementorLM and Mark Carew like this.
  3. DementorLM

    Builder

    Joined:
    Mar 3, 2022
    Messages:
    11
    Likes Received:
    4
    Awesome thank you! Did that today and it went well.
     
    sharmstr likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice