Welcome to Our Community

Some features disabled for guests. Register Today.

DIY Vacuum Hold Down table

Discussion in 'Other Builds' started by Mike Campbell, Oct 3, 2021.

  1. Mike Campbell

    Mike Campbell Well-Known
    Builder

    Joined:
    Jan 12, 2015
    Messages:
    36
    Likes Received:
    82
    Mike Campbell published a new build:

    Read more about this build...
     
  2. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,759
    Likes Received:
    2,443
    Very nice Mike! Having a vac table like this is such a game changer when setting up projects. Thanks for sharing
     
  3. Rink

    Rink Well-Known
    Builder

    Joined:
    Mar 7, 2020
    Messages:
    152
    Likes Received:
    33
    Good afternoon.
    Would a vacuum pump work?
    Thx, rink.
     
  4. Rink

    Rink Well-Known
    Builder

    Joined:
    Mar 7, 2020
    Messages:
    152
    Likes Received:
    33
    Good evening.
    It looks like you have another surface on top of your plenum grid board. Is that MDF? Did you shave off the surface on each side to help with the vacuum?

    Also, would a vacuum pump work well with this setup, in place of the shop vac?

    Thx, rink.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice