Welcome to Our Community

Some features disabled for guests. Register Today.

Homemade CNC Router (Under $400)

Discussion in 'CNC Mills/Routers' started by BunkerBuilder, Apr 30, 2021.

  1. BunkerBuilder

    Builder

    Joined:
    Apr 30, 2021
    Messages:
    1
    Likes Received:
    1
    BunkerBuilder published a new build:

    Read more about this build...
     
  2. LLPete

    LLPete New
    Builder

    Joined:
    Jan 20, 2018
    Messages:
    1
    Likes Received:
    1
    Thanks BunkerBuilder. I too am building a FrankenRouter out of parts I knew would come in handy 20 years ago, including old drawer glides and the frame of my daughter's childhood IKEA bunk bed that has some seriously good birch plywood. I wish I had a nickle for every bone headed mistake I have made, again and again and again. For the electronics though I am relying on the quality and expertise and advice of OpenBuilds. Not going to even try although I was an electronics tech way back in my military days.
     
    Peter Van Der Walt likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice